In this case, production times depend on the machine itself. You can obtain an increase, but not a significant one. What you certainly can obtain is a more consistent production, higher quality and a drastic reduction in waste.
During the initial stage, tests are on us.
Tests on horizontal machines can be carried out manually and are fairly reliable. Rotomatic machines require only automatic tests though.
With our technology, you can start production immediately without waste, which is ensured even after machine downtime.
Yes, of course. When it comes to rotors with a closed slot, the die where the reed valve is inserted is often not lubricated. Unlike the ones with an open slot, which require a minimum amount of lubricant.
The drying stage is essential for this type of production and it takes a long time. Our clients have increased their productivity by 10 to 30%, depending on the type of rotor produced.
Because we have eliminated the thermal shocks that occur when lubricating with water and the subsequent drying stage.
Capillary lubrication is one of the DLS’ strengths. The chemical and physical properties of the hot-melt powder ensure excellent penetration into the injection area, thus reducing capillary breakage drastically.
Yes. The DLS can be installed on three-plate horizontal and Rotomatic vertical die-casting machines. The type of installation is different, as traditional horizontal die-casting machines require the use of moving lubricant systems, unlike Rotomatic ones, which use fixed lubrications systems.