Zinc pressure die-casting
The most common difficulties that can occur during the zinc production process are due to the porosity and incompleteness of the casting, broken plugs, the handling of the carriages, mould temperature, etc.
Water- and solvent-based release agents affect both the production and quality, causing micro-porosity, micro-bubbles, etc.
The DRY LUB SYSTEM is a truly innovative lubrication system. Used in the zinc die-casting process, it eliminates many of the problems described above. The many systems installed have been operating successfully for many years, thus consolidating the performance of the DLS.
Increased flow of injected material
Less casting porosity
Improved surface treatments
No drying required for the dies
HOW THE DRY LUB SYSTEM WORKS
The use of wax-based release powders, which is already quite common, solves most porosity problems.
A small amount of wax is applied to the surface of the die. As soon as it touches it, the wax melts reaching even the most hidden spots.
Due to its chemical composition, the wax increases the flow of the injected zinc, thus forming a film external to the casting and reducing surface porosity drastically.
Watch it in action
Why should we use wax? The results we get are fairly good!
How is porosity reduced?
During the injection stage, zinc forms the external part of the shape and then the filling. The improved flow provided by wax and the lack of oils makes the film more compact and clean
Is it enough to reduce waste?
Yes! Our clients confirm it. Due to its heat-melting properties, wax increases the zinc flow, thus facilitating the filling of the casting. As a result, the pieces produced will have a more compact surface, even thanks to the absence of oils.
Why are surface defects visible only after the piece is finished?
During the polishing and painting stages, the hydrogen hidden under the surface tends to expand due to the heating process it undergoes, thus creating micro-cracks, which are visible only when the piece is finished.
Is the releasing power of wax really valid?
Wax is composed of the active substances of the release agent and does not contain solvents or water, which are only vehicles.
How does wax react when it comes in contact with the moulds?
When wax comes in contact with the mould, it melts and, due to its chemical and physical properties, it expands, reaching the most hidden spots.
At what temperature does wax melt?
Wax melts at 80 °C. It reaches its maximum efficiency when it exceeds 100 °C, which is the standard temperature of the production cycle. Only extremely light productions can experience temperature problems.
We produce both aesthetic and technical pieces. What benefits can we get?
The improved flow and release obtained with wax facilitate and improve the lubrication stage. Some of our clients manufacture pump bodies, air-pressure reducers, pneumatic valves, and occasionally lamps, without changing type of product.
Do bulky pieces increase temperature excessively?
Provided that the correct heat management of the mould is positive, wax is efficient at a temperature of up to 260 °C.
How much wax should be used?
The only reliable data that we could verify concern the production of cover-switch plates with an amount equal to 0.002 g per plate.
Often, wax is hardly visible during the spraying stage, and this can be a problem. We also have a client who consumes on average 5 Kg of wax a month, working 16 hours a day with six 125 ton machines.
Does testing wax cause production difficulties?
Manual and subsequently automatic tests can be carried on die-casting machines of over 125 tons. Results on smaller machines are achieved only with automatic systems that comply with the production schedule.
Is running tests expensive?
Initial tests are free of charge.